Baileigh IP-2511-HD, Руководство оператора

Страница: 20 / 56

17
17
TESTING MACHINE OPERATION
Once assembly is complete, test run your machine to make sure it runs properly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop
using the machine immediately, then review Troubleshooting.
Test Run the Machine:
1. Make sure you have read the safety instructions and check to ensure that your machine is
set up properly.
2. Make sure all tools and objects used during set up are cleared away from the machine.
3. Make sure the headstock cover is closed and secured and that all access panels are
securely attached.
4. Put on safety glasses and respirator; secure loose clothing and long hair.
5. Press the CUTTERHEAD MOTOR switch on the cutterhead/feeding control to turn the
cutterhead motor ON.
6. The planer should run smoothly with little or no vibration. Listen for any abnormal noises and
watch for any unusual actions.
If you suspect any problems, immediately stop the planer by pressing the red EMERGENCY
STOP button on the power/table control. Refer to Troubleshooting and fix any problems
before starting the planer again.
7. Use the and buttons on the digital control to raise and lower the table, and repeat
Step 6 for each direction.
After completing the
Test Run to your satisfaction, perform the following procedures to verify
that all of the safety features of this planer are operational.
Test the Emergency Stop lockout feature:
1. Start the planer by pressing the CUTTERHEAD MOTOR button on the cutterhead and
feeding control.
2. Now press the EMERGENCY STOP button and let the planer come to a complete stop.
Leave the EMERGENCY STOP button pushed in.
3. Press the CUTTTERHEAD MOTOR switch, There should be NO movement or action.
4. Attempt to move the table by using the digital controls. Press the and buttons, there
should be NO table movement or action of any kind.