Baileigh IP-2511-HD, Руководство оператора

Страница: 31 / 56

28
28
5. Determine which side of the table you will adjust to bring
the table parallel with the cutterhead (within 0.01mm).
6. Use the 12mm hex wrench to loosen the table elevation
housing bracket cap screws for that side of the table (Fig.
15).
7. Insert the long end of the 1/4" (6mm) round bar into the
leverage hole and turn the column until you are satisfied
with the table parallelism from side-to-side. (Fig. 16).
Note : The slight deformation of the rubber
elevation screw cover is normal and will not affect table
movement.
8. Tighten the cap screws holding the column in place.
Fig. 15
Fig. 16