Baileigh IP-208, Руководство оператора

Страница: 20 / 44

18
18
ROLL TRANSMITTING
The purpose of the roll located on top of machine, is
transmitting stock after cutting and shaving
workpieces. This roll will save you lots of time, and will
speed up you’re working rate. (Fig. 11)
CONNECTING DUST COLLECTOR
Connect dust collector system to hood of machine,
located at the back of machine. The dust collector will
collect all dust and particles while molding in process,
this system will give a clean and safe working
environment. (Fig. 12)
FEEDROLL PRESSURE AJDUSTMENT
The pressure of the feed roll will depend on the
pressure set by the springs, and screws.
To adjust the pressure, you must loosen or tighten the
lever. There are two sets of springs on both ends of the
feed roll, to ensure great results make sure both sides
are at the same level pressure. (Fig. 13)
Fig. 11
Fig. 12
Fig. 13