Baileigh IP-208, Руководство оператора

Страница: 18 / 44

16
16
CONTROL THE DEPTH OF CUTTING
The cutting depth scale is a combination of inch / metric
scale, the cutting range is from 0 to 8" (204 mm). The
distance between upward or downward of driving
handle is 0.059" (1.5mm) one complete turn.
Before adjusting the table upward, or downward; loosen
nut (A), after positioning to required position, tighten nut
(A) again to hold in position. (Fig. 5)
CHECKING PULLEY
To verify that motor pulley (B) is in line with the shaft
pulley of (A), using the edge of a straight scale check to
see if they are on-line with each other.(Fig. 6).
Adjusting Motor Mount
If motor pulley B and shaft pulley A, are not on-line
loosen screw as shown in (Fig. 7), move shaft to left and
right until adjusted to proper position and tighten the
screw again.
CAUTION:
Always wear proper eye protection with side shields, face
shield, safety footwear, and leather gloves to protect from, chips, dust, burrs, and
slivers.
Fig. 5
Fig. 7
Fig. 6