21
21
ROTATING AND ADJUSTING DIE
Note: Never install or use dies that are cracked, chipped, or otherwise damaged.
Make sure dies are the correct size and type to reduce the risk of overload.
1. Start the machine and lower the punch to the bottom of the stroke.
2. Loosen the four adjusting bolts (A) which secure the die to the bolster.
3. Install the lift hooks (B) on both ends of the die and raise the ram to the full up position to lift
the lower die.
4. With the die elevated: Slowly rotate to the desired
position and carefully lower the die down onto the
bolster.
5. Lower the punch gently into the selected V-groove
of the bottom die to position it (C).
6. When the ram is near the lower die, check if the
clearance between the punch and the die, is equal
within the whole length. If not, use the adjusting
bolt (A) to adjust the lower die. Make the
clearance equal within the whole length.
7. When aligned, tighten the clamps EVENLY and
securely.
WARNING:
Always keep hands and fingers from between the punch and
die. The die supplied with the press is heavy. Use the lifting hooks provided.
B
B
A
A
C
A
Содержание BP-4830
