Baileigh AS-350M, Руководство оператора

Страница: 19 / 36

17
17
ASSEMBLY AND SET UP
Attach the stop bar to the stand.
•
Insert the threaded end of the long rod (V) into the
side of the stand as shown in the photo.
•
Turn clockwise (cw) until snug.
•
Using a wrench, turn hex jam nut (N) clockwise (cw)
until tight.
Feed handle assembly and orientation.
•
Screw the handle rod (H) clockwise (cw) into the drive shaft
hub. The keyslot for the cable should face down or towards
the operator. Tighten the jam nut.
•
Slide the trigger switch handle (O) onto the handle rod so
the cable exits the keyslot as in the diagram. Attach with (2)
flathead screws. Trigger switch should now point away from
the operator as in the photo (below).
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
H
V
N
O