20
20
OPERATION
Miter Angle
•
Use the miter lock lever (M) to release the disk head
assembly.
•
Rotate the disk head assembly to the correct miter angle.
•
Check the miter angle on the angle indicator (F) (below the
vise).
•
Use the miter lock lever (M) to lock in the angle.
Vise Operation
Use the hand wheel (L) to open and close the vise jaws (K)
for pieces that vary in width.
•
Counter clockwise (ccw) to open jaws.
•
Clockwise (cw) to close jaws.
Use the vise lever (B) to quickly clamp and unclamp pieces
of the same width.
•
Clockwise (cw) to clamp the piece.
•
Counter clockwise (ccw) to unclamp the piece.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
NOTICE: Verify that the cutting blade clears all parts of the vise assembly before cutting.
The blade can strike parts of the assembly (especially during miter cuts) if not properly
adjusted.
NOTICE:
DO NOT allow the vise base to open beyond the travel limits of the slide rails or
the assembly may de-rail. (See arrow)
M
F
L
K
B
Содержание AS-350M
