Baileigh Industrial HSP-50A, Руководство оператора

Страница: 21 / 36

19
19
Hanging the Cylinder Assembly
1. Move the cylinder assembly (34) to the outside of the base frame (32) as shown and attach
to the frame members using four M10 x 20mm hex bolts (47) and flat washers (48). Tighten
securely. Position the foot operated air valve on the floor.
Attaching Hydraulic Lines
1. Turn valve (50) counterclockwise (ccw) to relieve any
pressure in the system.
2. Remove and discard the plugs (A) from the end of the
pressure hose and from the elbow fitting.
3. Connect the pressure hose to the fitting and tighten.
4. Remove the compression fitting (B) from the top of the
reservoir.
5. Remove and discard the plugs from the compression fitting
and from the end of the tube (C).
6. Slide the compression fitting nut over the tube and then
install the tube onto the compression fitting bayonet.
7. Firmly tighten the compression nut onto the fitting without
causing damage to the tube or the fitting.
34
32
47
50
48
48
47
A
B
C