Baileigh Industrial HSP-110M-HD, Руководство оператора

Страница: 28 / 48

25
25
Pressure Gauge
The pressure gauge is located in the head of the press. The gauge gives the pressure in PSI
and BAR. The maximum pressure for this press is 3814psi. (263 bar).
If this maximum pressure is reached, also the maximum capacity of the press is reached.
Pressure Regulation Valve
The pressure regulation valve is located on the hydraulic control valve. With this valve the
maximum pressure, referring to the maximum press capacity, can be changed. Turning the
adjustment clockwise will increase the pressure, turning the adjustment counter clockwise will
decrease the pressure. Adjusting the pressure to meet the material can be very beneficial in
completing the pressing operation while reducing the change to damage the piece part.
Working at reduced pressure when available will also reduce the stress on the press and the
hydraulic system. Use the chart next to the pressure gauge to determine the pressing force at
the pressures listed.
Pressure Adjusting
1. Start the hydraulic unit.
2. Make sure the piston is in rest position (no
force applied).
3. Set the table height in the top position.
4. Place the heal blocks on the table.
5. Remove the acorn nut.
6. Loosen the jam nut (A) and turn the
adjustment screw counter clockwise 1/2 to 1
full turn to reduce the pressure. Do not
overturn and remove the screw!
7. Extend the ram down until it reaches the
heal blocks. Hold the lever in the down
position and read the pressure on the
pressure gauge.
8. Slowly turn the adjusting screw in or out as
desired to set the desired pressure. NEVER
EXCEED THE MAXIMUM PRESSURE
SETTING!
CAUTION:
NEVER EXCEED THE MAXIMUM PRESSURE SETTING!
A