Baileigh Industrial DP-1375VS-110, Руководство оператора, Страница: 23 / 48

21
21
SET UP AND ADJUSTMENTS
Raising the Machine Head
The machine head is lowered for shipping and must be
raised before operating.
1. Unlock the table by turning crankshaft (A)
counterclockwise (ccw).
2. Place a piece of wood (B, typically shipped in place)
between the table and the drill head frame. (DO NOT
place the wood under the collar.
3. Raise the table (C) just enough to hold the block of
wood (B) in place.
4. Using the wrench provided, loosen the clamping
nut (D) on the machine head.
5. Turning either crankshaft (C) clockwise (cw) will
raise the head.
6. STOP when the top of the machine head is flush
with the top of the column. DO NOT allow the
column to be below the top of the head.
7. Using the wrench, lightly tighten the clamping nut
(D).
8. Loosen the two setscrews (E) on the collar and
slide the collar up tight to the machine head and
tighten the setscrews.
9. Loosen the clamping nut and turn the crankshaft
(C) just enough to place some of the drill head
weight onto the collar.
10. Securely tighten the clamping nut (D).
11. Once the machine head is safely secured, remove
the block of wood.
12. To lower the head, reverse the above steps.
WARNING:
Failure to lock the collar can result in personal injury or
damage to the machine.
A
C
C
D
B
E