Baileigh Industrial DP-1375VS-110, Руководство оператора, Страница: 17 / 48

15
15
•
POWER SUPPLY PLACEMENT: The power supply should be located close enough to the
machine so that the power cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.
Anchoring the Machine
•
Once positioned, anchor the machine to the floor, as shown in
the diagram. Use bolts and expansion plugs or sunken tie rods
that connect through and are sized for the holes in the base of
the stand.
•
This machine requires a solid floor such as concrete at a
mi
nimum of 4” (102mm) thick. 6” (153mm) minimum is preferred.
Mounting Holes
.31"
(7.87mm)
.50"
(12.7mm)