Baileigh Industrial DG-500, Руководство оператора

Страница: 20 / 28

18
18
POSITIONING A PIECE PART TO THE DISC FACE
No matter what size or type piece part you will be sanding or grinding on the
DG-500 , there are
several important points to consider.
1. Always be sure that the wheel guard is positioned over the disc edge. Dust and grit removed
from the piece part can be hurled off the wheel if the wheel guard is not in position.
2. Always allow time for the disc to come up to full speed before contacting the piece part to the
disc.
3. This is a very powerful and aggressive grinding device which operates at high surface
speeds, so you always want to properly support the piece part while using the work table.
4. The safest position at which to do
any grinding is on the right-hand
side of the work table where the disc
is moving downward past the work
table. Whenever possible, keep the
workpiece in this area when
grinding. In addition to safety,
keeping the piece part in this area
greatly increases the effectiveness
of the dust control chute and any
vacuum dust control system you
might be using.
5. The speed and aggressiveness of the machine means that CONTROL of the piece part is
absolutely essential. ALWAYS USE TWO HANDS to control the piece part.
6. Because of the speed with which the disc can grind, heat build-up on piece parts is usually
very quick.
7. To prevent burns and/or possible loss of control of any piece part:
a. Use heat resistant gloves to hold the piece part.
b. Where possible and appropriate, use additional tooling or fixturing to hold the
workpiece when pressing against the grinding disc.
WARNING:
All machinery poses a potential for danger when being
operated. Accidents result from lack of machine knowledge and failure to pay
attention. Always be cautious and alert to the potential for serious injury. Follow
safety rules and precautions to lessen the chances of an accident.
Rotation
Table
Most Effective Work Area
(Abrasive force of rotating
disc tends to hold piece
part to the table).