Baier PROMETHEUS Series, Инструкция по эксплуатации

Страница: 15 / 22

24V motor control device for flush box mounting - Version 1.1 Instruction manual
15/22
6
Initial operation
w w w .b ai e r- g mb h .d e
6.2 Steps during initial operation
W A R N I N G
Moving wing
Danger of injury by squashing, shearing or collision, caused
by moving wing.

Wing moves independently during initial operation.

Keep danger area clear during initial operation.

Prepare eletrical connections

Refer to chapter 5.4

Set configuration

Refer to chapter 6.1

Switch power supply on

Control device in delivery status or after power cut:
Red LED blinks continuously twice with a short break of 1.5 sec

Press RESET for 2 seconds

Red LED blinks continuosly

Check driving direction of motor
When pressing OPEN, wing has to open and when pressing CLOSE, wing has
to close

When driving direction is wrong:
Swap motor cables (clamp 4 and 5), check driving direction again

Press RESET again for 2 seconds

Red LED lights up permanently,
Green LED lights up, when motor is active

Drive performs a few runs.

LEDs go out

Red LED starts blinking continuosly

In this state (about 30 seconds) additional complete cycles may be performed.
These cycles have to be triggered by user and are optional.

After 30 seconds without any function, the LED goes out

Check desired function

In case of malfunction, check electrical connections and configuration

Electrical connection, refer to chapter 5.4

Configuration, refer to chapter 6.1

Repeat initial operation, if necessary

Initial operation is completed, when function is correct
Prepare control device
Reset control device
Check function
…
…
…
…