DISPLAY MANUAL DP C10.UART
13
Error code
Error definition
Error-shooting method
“03”
Brake fault
Check if brake cable is stuck
“04”
The throttle has not returned home
Check if throttle has returned home
“05”
Throttle fault
Check the throttle
“06”
Low voltage protection
Check the battery voltage
“07”
Overvoltage protection
Check the battery voltage
“08”
Motor hall signal cable fault
Check the motor module
“09”
Motor phase cable fault
Check the motor module
“10”
Temperature of motor too high
Check the controller
“11”
Controller temperature sensor failure
Check the controller
“12”
Current sensor failure
Check the controller
“13”
Battery temperature fault
Check the battery
“14”
Motor temperature fault
Check motor
“21”
Speed sensor fault
Check installation position of speed sensor
“22”
BMS communication fault
Replace the battery
“30”
Communication fault
Check the controller connection
ERROR CODE DEFINITION
The DP C10.UART display can show e-bike faults. When a fault is
detected, the icon
will be displayed. In the speed field one of
the following error codes will be displayed:
Hint warning interface
