DISPLAY MANUAL DP C10.UART
10
PARAMETER SETTING
1
5
3
7
10
2
6
9
4
8
• Items to be Set
Data reset
Km/mile
Light sensitivity
Display backlight brightness
Automatic off time
Maintenance warning settings
Check wheel diameter
Speed Limit Setting
Speed model
Battery information
• Setting Preparation
1) When the display is active, press twice
(interval < 0.3
seconds). The system will enter the MENU parameter setting
state, in which the display parameters can be set. Press
twice again (interval < 0.3 seconds) to return to the main menu.
2) If no operation is performed for 10 seconds, the display will
return to the normal riding display.
3) In the parameter setting state, when the parameter you want
to set begins to flash, press
/ to adjust the parameter value.
Briefly press
to switch between the parameters to be set.
Press
twice (interval < 0.3 seconds) to exit the submenu.
• Data reset
Press
twice (interval < 0.3 seconds) – the display enters the
MENU state. In the speed field tC is displayed. If you press
, a "y"
is also displayed. Now all temporary data, e.g. maximum speed
(MAXS), average speed (AVG) and single trip distance (TRIP) can
be cleared. Briefly press
(< 0.3 seconds) to enter the
km/mile setting interface.
If the user does not reset the data, the single trip distance and
the accumulated total riding time will be automatically cleared
when the accumulated total riding time exceeds 99 hours and 59
minutes.
* The data will not be cleared when the display’s light-sensing
function is set to 0 or when it is switched off!
• Km/mile
When the speed field displays S7, press
/ to switch between
km/h and mph, or to set km or mile. After this setting, briefly
press
(< 0.3 seconds) to enter the setting interface of light
sensitivity. Default display is km.
• Light Sensitivity
When the speed field displays bL0, press / to choose a figure
between 0 and 5. The higher the chosen figure, the higher the
light sensitivity.
