ORION® SE Gateway Transceiver
4.
Place new battery in unit with the battery label (“This Side Out”) visible and upright (see "Figure 17: Battery Remov-
al" on page 15).
5.
Carefully install the battery connector onto the circuit board. Connector needs to be inserted only far enough so
that the connector latch engages. Verify proper connector polarity is observed (see "Figure 16: Battery Connector"
on page 15).
6.
Install the new enclosure cover provided with the battery kit. Tighten each of the four cover screws (DO NOT over-
tighten).
Battery Disposal
Dispose of the used battery per the local environmental standards for non-spillable, lead acid batteries. Badger Meter does
not perform battery disposals unless per mutual contractual agreement.
Page 16
(1-11)
