IR Head Bracket
IR HEAD BRACKET
To facilitate reading and programming multiple encoders, the IR head bracket is recommended . The bracket is easy to attach
and remove .
Attaching the bracket to an encoder
1 . Open the lid of the encoder .
2 . With the bracket guide pointing to the encoder lid hinge, slide the bracket onto the encoder (
fits on both sides of the hinge .
Push gently to make sure the bracket guide is completely seated against the encoder lid hinge, and you can see the
IR port through bracket opening as shown in
.
Figure 1: Slide bracket onto encoder
Figure 2: Bracket attached to encoder - top view
3 . Place the optical head of the IR cable in the bracket,
with the nubs on the back seated in the slots of the
bracket . See
. This placement facilitates correct
alignment between the IR head and the encoder
IR port .
The encoder is ready for programming .
Figure 3: Head of IR cable inserted
Removing the bracket from an encoder
When you are finished programming an encoder, remove the bracket .
Hold the encoder with one hand and pull the bracket gently with the other hand, straight off the encoder . The bracket should
come off will little resistance .
Page 6
May 2018
ENC-PM-02040-EN-03
Содержание HR-E LCD 4-20
Страница 2: ...High Resolution LCD Encoder Programmer Page ii May 2018 ENC PM 02040 EN 03...
Страница 4: ...High Resolution LCD Encoder Programmer Page iv May 2018 ENC PM 02040 EN 03...
Страница 19: ...Appendix APPENDIX Page 19 May 2018 ENC PM 02040 EN 03...
Страница 23: ...Programmer Manual INTENTIONAL BLANK PAGE Page 23 May 2018 ENC PM 02040 EN 03...