Bad Boy Q0378, Руководство оператора

Страница: 5 / 22

5
Section I
INTRODUCTION &
DESCRIPTION
1-1 Introduction
Your grass collection system has been designed to give
you a low maintenance, simple, and effective way to
collect the grass clippings from your mower. This manual
is provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE:
all references made to right, left, front, rear, top
or bottom are as viewed from the normal operator’s
position on the mower.
1-2 Description
The grass collection system is designed for turf
maintenance where there is a need to collect the grass
clippings as the mower cuts the turf. It is also used for
picking up leaves in pre-season and post-season clean-
up.
The blower, mounted on the right side of the unit, uses a
belt and gearbox system from the engine PTO shaft.
Drive train protection comes through belt slippage. The
blower draws grass clippings from the discharge area of
the cutting deck back to the (2) - 2.9 cubic foot collection
bags P#(G0004) at the rear portion of the mower frame.
The operator can engage the blower with a spring-lock
engagement handle on the right side of the unit. Once
the bags are full with clippings, they can be released to
make for easy dumping.
Section II
INSTALLATION FOR USE
2-1 Preparation Of Mower
Carefully open the shipping box. The grass collection
system will have various parts located inside. Remove
and sort all parts for easy identification. Verify all parts
against the list on page 13 and 14. If parts are missing,
please contact PECO Inc. at (800) 438-5823.
NOTE: Before each step of assembly it will help to study
the exploded drawings on pages 13, 14, 15 and 16.
2-1 Continued...
From the underside of the engine, remove the bolt and
bushing from the electric clutch assembly. Use a bungee
cord or similar device to hold the clutch in place while
the hardware is removed.
Replace the hardware removed with the engine pulley
assembly number 1 P#(A0198). Fasten the engine
pulley to the electric clutch assembly using (1) 7/16” hi-
collar helical spring lock washer P#(K0140) and (1)
7/16”-20 x 3-3/4” HHCS P#(K0350). See Figure 2-1 for
details.
The added pulley will power the collection system.
Torque the bolt to 55 ft./lbs.
2-2 Right Frame Mount Assy. Installation
On the right side of the rear bumper plate, align the right
frame mount assembly P#(A1023) to the (4) square
holes in the rear bumper. See Figure 2-2a. Fasten the
lower portion of the right frame mount assembly using
(4) 5/16”-18 x 3/4” carriage bolts P#(K1142) and (4)
5/16”-18 flange nuts P#(K1178).
Clamp the top portion of the right frame mount assembly
by positioning the clamp bracket P#(B0302) as shown in
Figure 2-2b and fasten using (2) 3/8”-16 x 3/4” HHCS
P#(K1190) and (2) 3/8”-16 flange nuts P#(K1215).
See next page for Figure 2-2a and Figure 2-2b.
Figure 2-1
Electric
Clutch
(Existing)
Engine
Pulley
Assembly
7/16”
Helical
Spring
Lock
Washer
7/16”-20 x 3-3/4”
Hex Bolt