Bad Boy Outlaw Stand-On BBS 3600, Руководство владельца, обслуживания и запасных частей

Страница: 30 / 56

PAGE
30
Leveling the Deck
1)
Start on a flat level surface and set the air
pressure in all four tires to 12 psi.
2)
Raise the deck u p, and measure all f our
corners of the deck to see i f i t i s l evel f rom left
to right and front to back. A ll decks s hould be
level from left to right and h ave a
1/8˝ pitch
down i n the front.
3)
Adjusting the deck hangers in the rear of the
deck will allow leveling from left to
right.
4)
Use 2x4s to lift the rear of the deck to the
point that the deck stop hits the frame rail.
Once the deck stop hits the frame rail, loosen
the nuts on the bottom of the deck hanger
using two ¾” wrenches.
5)
Raise the deck actuator arm on the podium
and refasten the two nuts on each side once
there is no slack in either deck hanger.
6)
Adjust the turn buckles in the front of the deck
to adjust the pitch up and down.
7)
In order to use the turn buckles you must first
use a crescent wrench and loosen the nuts on
each side. Use a screwdriver in the middle
hole on the turn buckle to spin the unit up and
down to adjust the pitch and leveling.
8)
Verify that the deck is level and has the
correct pitch with a level and tape measure.
Note that the deck will lose pitch as it drops to
its lowest position.