4
1. Position the rubber gasket down onto the circular flat surface in the blade base.
2. Holding the blending jar upside down, screw the blade base onto the bottom of
the blending jar by twisting the blade base counter-clockwise until tightened.
Make sure that the blade base is tightly fastened to the blending jar and that the
rubber gasket is properly compressed between the blending jar and the blade
base. Place orange locking ring into the bottom of the blade assembly until it
locks in place and the ring lies flat with the bottom of the blade assy.
3. Press the lid onto the top of the blending jar. Press the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
4. Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5. Plug in the cord. Your smoothie maker is now ready to use.
U
SING
Y
OUR
S
MOOTHIE
E
LITE
™
C
ONTROL
B
UTTONS
:
PULSE - gives short bursts of power at high speed.
Use “PULSE” to begin the mixing of ice and other hard
ingredients.
OFF - turns off the appliance.
LOW/DISPENSE - runs the unit at low speed. Use
this speed for the initial 30 seconds of mixing as well
as for dispensing.
HIGH – runs the unit at high speed. Use this speed for
the final 10 seconds of mixing. Do not use this speed
for dispensing.
To make your favorite frozen drinks, follow the steps below.
1. ADD LIQUIDS – Add any combination of liquid ingredients up to the LIQUIDS
mark under SERVES 2 or SERVES 4 located on the blending jar. Liquids
include any soft ingredients such as fruit, milk, fruit juice, herbal supplements, or
yogurt in any combination you think would be tasty.
2. ADD ICE – Add ice or frozen ingredients until the total level reaches the
FROZEN INGREDIENTS line on the side of the blending jar. Frozen ingredients
include ice, frozen fruit, frozen yogurt, ice cream, etc.
3. SMOOTH IT – With the lid on and the stir stick (use as directed below) set in the
hole on the lid, pulse the mixture 2 or 3 times by pressing the “PULSE” button.
Then press the button to “LOW” for 30 seconds, or until ingredients are mostly
blended. Run appliance at “HIGH” for the final 10 seconds of
blending.
STIR STICK OPERATION – When in use and while the
machine is running, stir or rotate the Stir Stick in a counter-
clockwise direction so that the Stir Stick scrapes or contacts
the sides of the blending jar. This stirring operation will force
the ingredients into the mixing blades.
4. SERVE IT – To serve the smoothie, press the
“LOW/DISPENSE” button, place a cup under the valve and
press down the valve lever. Stir the contents in the blending
jar with the stir stick while dispensing thick smoothies. As the
