Bacharach 19-8104, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 36

Instruction 19-9326 9
Monoxor III
1. Enter the Setup Mode per Secton 3.4.1. If necessary, repeatedly
press ENTER untl the Temperature Unts Setup Screen s dsplayed.
2. Press the

or

button untl the desred temperature unt
(°F or °C) s dsplayed.
3. Press
ENTER
to move to the next Setup Screen, or
I/O
to ext setup.
3.4.3 CO Channel Zero Setup
The CO Channel Setup Screen s labeled “CO”.
1. Enter the Setup Mode per Secton 3.4.1. If necessary, repeatedly
press
ENTER
untl the CO Channel Setup Screen s dsplayed.
2. Press the

or

button untl the desred parameter s dsplayed.
- no Sensor disabled. Note that when the CO sensor s ds -
abled the CO measurement screen wll dsplay “Err” n -
stead of the current CO level.
- 2Ero Manual Zero – Warm-up time is 10 seconds, and the
analyzer does no t zero the CO sensor to ambent condtons
durng ths perod. For example, f the atmosphere con -
tans 25 ppm CO at start up, the analyzer wll mmedately
dsplay 25 ppm. The zero pont, however, can be manually
adjusted by performng Steps 1–4 of Secton 5.3.
- A2 Auto Zero – Warm-up time is 60 seconds, and the CO sen-
sor s zeroed to the ambent CO level durng ths perod. For
example, f the atmosphere contans 25 ppm CO at start up,
the analyzer wll dsplay 0 ppm. It’s very important that
when in this mode the analyzer be turned ON in fresh
air; otherwise, incorrect CO readings will occur.
3. Press
ENTER
to move to the next Setup Screen, or
I/O
to ext setup.