12
Rearward Facing - For Baby Use
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If
the angle of the seat causes the baby to be too upright for
comfort, the angle may be altered by placing a firm packing
between the seat and the underside of the base. Packing can
be a firmly rolled up towel or nappy.
Do not remove all of the rearward slope by over packing.
Always leave a rearward slope angle of approximately 10°.
10°
HOW TO USE
HOW TO USE
Slackened Upper
Anchorage Strap.
Harness
shoulder
straps.
Lift up
Adjuster.
D
E
Lay baby on its back into restraint and fit harness.
Make sure baby is dressed to allow harness buckle to
be pulled up between baby's legs e.g. a jump suit.
Make sure baby's arms and legs are free. Never wrap
Fit either harness tongue into the harness buckle
followed by the other tongue until a click is heard.
Ensure secure
engagement by pulling harness straps.
Should the second tongue not insert, press the red
button and reinsert the tongues.
Click
HOW TO INSTALL
HOW TO INSTALL
Rolled up towel
Up to 8kg
Up to 8kg
Up to 12kg
Lift Harness Adjuster Lever,
grasp both shoulder harness
straps and pull out till there is
enough slack to place harness
to each side of restraint.
C
Pull Straps
Lift Adjuster Lever
Check that the harness shoulder
straps are in the correct position.
Refer to page 6 for correct
shoulder harness strap height.
Ensure Upper Anchorage Strap is
attached to Anchor Fitting, then
slacken Upper Anchorage Strap
and allow to fall to the sides of the
restraint for easy access to baby.
B
A
