6
*
The cover of the child/car seat tray may be fastened in the closed position
after your child outgrows the infant car seat. This will prevent an older
child from opening the child tray. To secure the tray cover, remove the
tray from the stroller as shown in the to remove front child tray section.
Install the tray cover. Place the tray with the lid side down on a soft
flat surface. Remove the screw stored under the tray as shown in figure
21. Insert the screw into the hole in the bottom of the tray and into the
matching hole in the cover. Tighten until snug. Do not over tighten. If
you wish to use the car seat tray function at a later date (for a second
child) remove the screw and store in the tray bottom as before. Please
see figure 21.
FRONT CHILD / CAR SEAT TRAY COVER
SEAT BACK POSITIONING
WARNING:
The upright position should be
used only for a child that is at least 6 months old.
* The seat has a multiple position recline that is controlled by a strap and
buckle assembly behind the seat. To recline the seat, loosen the strap
through the buckle and adjust to the required recline position. Please see
figure 22. To place the seat back in a more upright position, press upward
on the seat back with one hand while pulling the straps through the buckle
with the other. See figure 23. The strap will lock automatically.
Strap must go across slot on either side of central seat body when
adjusting seat back height. See figure 23a.
BRAKES
WARNING:
Always set brakes when the
stroller is not being pushed so that the stroller will
not roll away. Never leave stroller unattended on a
hill or incline as the stroller may slide down the hill.
* To engage brakes, apply light downward pressure to the brake lever
located on each rear wheel. The stroller may require slight forward or
rearward movement in order to line up the teeth on the brake with each
wheel brake cluster. See figure 24. Check that the stroller will not move
and that the brakes are properly applied. To release, gently lift up on the
brake lever.
Figure 22.
Figure 23.
Figure 24.
Figure 21.
Screw storage
boss-factory
installed screw
for later use
Hole in tray to lock down lid
after car seat use
Figure 23a.
