10.0
Operation and Adjustments
79
The harness can be adjusted to four different heights. The proper height
of the harness straps is at or just above your child’s shoulders. If your
child’s shoulders are between two levels, always use the higher of the
two. Remove the body insert if your child’s shoulders are above the
highest set of harness slots.
To adjust harness strap height, remove harness straps from back
support, move to height at or just above child’s shoulder and re-attach
harness straps.
Follow the instructions very closely to ensure that the harness is
properly adjusted to fit your child at all times. Check the fit of the
harness every time you use the Car Seat.
Note: Discontinue use of Body Insert when child’s shoulders are at or
above top harness strap slots.
To remove Harness Straps from Back Support:
a. Loosen the Harness Straps by depressing
the Harness Adjuster and pull out on the
Harness Straps .
b. From the back of the car seat, locate the Belt
Adjuster Plate and remove both Harness
Straps from the Belt Adjuster Plates. Be sure
to note how the Harness Straps are attached
to assist in reattaching.
c. From front of car seat, pull Harness Straps out
of Harness Strap Slots and out through front of
car seat.
10.0
Operation and Adjustments
80
To re-attach Harness Straps in the new height positions:
Re-attach the Harness Straps at the required height by placing the
Harness Straps into the matching harness straps slots in the Back
Support Pad and Back Support,
a. Thread the Harness Strap through the Harness
Slots in the Seat Pad and Back Support at the
height at or just above the child’s shoulders.
Note: Make sure that the Harness Straps are
through the Harness Strap Slots at the same height
in the Back Support pad and the Back Support.
b. From back of car seat, pull Harness Straps through
the Harness Strap Slots in back support until you
have enough strap to reach the Belt Adjuster Plate
c. Hook the looped end of each harness strap to one
of the Harness Connector Plates and .
Ensure that the straps are securely connected to
the connector plates .
d. Inspect the Harness Straps from the front and back of the car
seat to ensure that they are not twisted. Twisted harness straps
can prevent proper tightening of the harness and thus may not
adequately restrain your child in a sharp turn, sudden stop or crash.
Before Using the car sat, please pull on the harness straps from the
front of the car seat to ensure they are securely re-attached.
1
2
3
1
1
2
2
3
2
1
