12.0
Cleaning and Maintenance
91
To Remove Head Support Pad:
• Slide elastic loops out of inner shoulder belt slot.
• Pull pad off head support.
To Remove Back Support Pad:
• Remove harness (see “Harness Removal and Assembly”
section).
• Remove back support from Seat Base (see “Assembly and
Removal of Back Support” section).
• Unhook top of pad from top of back support.
• Unhook elastic loops top corners of pad from plastic pins on
back support.
• Unkook elastic loops from bottom corners of pad from plastic
pins on back support.
• Slide back support pad off of back support.
To Remove Vehicle Shoulder Belt Positioner:
• From back of car seat, unthread the Shoulder Belt Positioner
from the loop end.
• Store the Shoulder Belt Positioner in pouch located on side of
seat base.
WARNING!
• DO NOT use Car Seat without seat, back support and head
support pads.
12.0
Cleaning and Maintenance
92
To Remove Seat Base Pad:
• Remove harness and crotch strap (see “Harness Removal and
Assembly” section.
• Unhook elastic on rear corner of
pad from plastic pin. Repeat on
opposite side.
• Slide the base seat pad armrest
covers forward and off armrests.
Slide entire seat pad forward,
pulling elastic bands off from under
cup holders and off the front of the
Car Seat.
Reverse above steps for replacing pads and harness
system.
Cleaning Harness System:
• Surface wash only with mild soap and water. Rinse with
clean water. Air dry.
DO NOT launder the straps as they may become damaged or
weakened. Contact Baby Trend customer service or order
replacement straps.
Elastic
