Baby Lock Jubilant BL80B, Инструкция и справочник

Страница: 14 / 68

Winding/Installing the Bobbin
12
Winding the bobbin
This section describes how to wind thread onto a bobbin.
a
Place the bobbin on the bobbin winder shaft so that the
notch in the bobbin aligns with the spring on the shaft,
and then slide the bobbin winder shaft to the right until
it snaps into place.
b
Remove the spool cap and place the spool of thread for
the bobbin onto the spool pin.
Slide the spool onto the spool pin so that the thread
unwinds to the front from the bottom. Otherwise the
thread may become tangled around the spool pin.
1
The thread unwinds to the front from the bottom.
c
Slide the spool cap onto the spool pin.
Slide the spool cap as far as possible to the right, as
shown, with the rounded side on the left.
d
Pass the thread under the thread guide, then under the
thread guide cover and to the front.
1
Thread guide
2
Thread guide cover
Winding/Installing the Bobbin
CAUTION
• Only use the plastic bobbin that comes with
this machine or bobbins of the same type
(X52800-120). The bobbin's height is 11.5 mm
(approx. 7/16 inch). Using other bobbins may
cause damage to the machine. X52800-120 is
Class 15 type bobbin.
1
Notch in the
bobbin
2
Bobbin winder
shaft spring
2
1
1
CAUTION
• If the spool or the spool cap is not installed
correctly, the thread may become tangled
around the spool pin, causing the needle to
break.
• Three spool cap sizes are available, allowing
you to choose a spool cap that best fits the size
of spool being used. If the spool cap is too
small for the spool being used, the thread may
catch on the slit in the spool or the machine
may be damaged.
For details on thread spool insert, refer to
“Memo” on page 12.
Memo
• When using the spool as shown below, use the small
spool cap, and leave a small space between the cap
and the spool.
• When using thread that winds off quickly, such as
transparent nylon thread or metallic thread, place the
spool net over the spool before placing the spool of
thread onto the spool pin.
If the spool net is too long, fold it to fit the size of the
spool.
1
Spool cap (small)
2
Spool (cross-wound
thread)
3
Space
2
1
3
a b