Baby Lock emore BLMR, Инструкция и справочник

Страница: 40 / 92

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
38
Checking the needle
Embroidering with a bent needle is extremely
dangerous since the needle may break while the
machine is being operated.
Before using the needle, place the flat side of the
needle on a flat surface and check that the distance
between the needle and the flat surface is even.
a Flat side
b Needle type marking
CAUTION
Replacing the needle
Replace the needle as described below. Use the
screwdriver and a needle that has been determined to
be straight according to the instructions in “Checking
the needle”.
a
Press (“Needle Position” button) once or
twice to raise the needle.
a “Needle Position” button
b
Turn off the machine.
CAUTION
c
Lower the presser foot lever.
a Presser foot lever
d
Place fabric or paper under the presser foot to
cover the hole in the needle plate.
Note
z
Before replacing the needle, cover the hole
in the needle plate with fabric or paper to
prevent the needle from falling into the
machine.
●
If the distance between the needle and
the flat surface is not even, the needle is
bent. Do not use a bent needle.
a Flat surface
1
2
1
1
●
Before replacing the needle, be sure to
turn off the machine, otherwise injuries
may occur if
/ (“Start/Stop” button)
is accidentally pressed and the machine
starts embroidering.
1
1