Baby Lock Coronet User Manual
| 13
Rear and Front Views
27. On/Off Switch
28. Power Cord Connector
29. Accessory Power Outlet
30. Serial Port for Stitch Regulator
31. Laser Light Stylus Power Connector
32. Rear Handlebar USB Connector
33. Rear Threaded Handle Holes
34. Spool Pin 1
35. Electronic Control Pod (C-Pod)
36. Bobbin Assembly
37. LED Light Ring
38. Power Pod (P-Pod)
39. Spool Pin 2
Rear
Front
29
28
27
38
30
39
35
34
37
36
33
31
32
Installation and Setup
Carriage
You should have already set up the Coronet Frame. Refer to the frame manual for detailed instructions
about setting up the frame.
To install the carriage and machine on the frame
1.
Place the carriage on the table rails, ensuring
that the stitch regulator faces the back of the
frame.
2.
Place the machine on the carriage.
U
CAUTION: The Baby Lock Coronet is heavy.
Never attempt to lift it alone. Always use
two people when lifting. Always lift from
the throat of the machine, not from the
handlebars or needle bar.
3.
Plug the ribbon cable from the stitch regulator
connector at the back of the machine (see Rear
View on the previous page, #30) into the stitch
regulator on the carriage.
Â
IMPORTANT: If you ever need to remove the machine from the carriage, disconnect the ribbon
cable from the stitch regulator at the back of the carriage. Failure to unplug the cable when
removing the machine from the carriage could result in damage to the cable, encoders, and
carriage.
Â
IMPORTANT: The connector is keyed to ensure correct alignment. Make sure the keyed portion of
the cable connector aligns with the keyed portion of the encoder connector. Do not force.
