Baby Lock Acclaim BLES4, Инструкция и справочник

Страница: 25 / 64

T
H
R
E
A
D
I
N
G
22
How to change the Threading Mode
1. Connecting the power supply.
2. Power switch is in the OFF position.
3. Press and hold the " Push to thread needles button", turn power switch ON while holding button
for over 3 seconds.
4. Threading Mode changes "Mode 1"
⇒
"Mode 2"
⇒
"Mode 3"
⇒
"Mode 1"
・・・
.
This guide is designed to aid if having difficulties with needle eye
thread placement when using the RevolutionAir Needle Threader.
How to use RevolutionAir Needle Threading Guide
1. Set up the Acclaim for needle threading. (see page 21, 1 to 6)
2. Clip the upper section of the RevolutionAir Needle Threading
Guide onto the needle bar and the guide’s lower section against
the needle clamp. (fig. A)
3. Make sure RevolutionAir Needle Threading Guide is
completely set up just in front of the needles. (fig. B)
4. Place the end of thread directly in front of the desired needle eye
position. (fig. C)
5. Press the "Push to thread needles button". (see page 21, 7 to 9)
6. Remove RevolutionAir Needle Threading Guide. (fig. D)
7. Set the threading lever to serging position.
8. Close the blade cover and the front cover.
Note: The elastic applicator foot cannot be attached when using the
"RevolutionAir Needle Threading Guide"
Needle Threading Mode
RevolutionAir Needle Threading Guide
Acclaim has 3 types of threading Modes.
MODE 1:
Press the " Push to thread needles button"
once, threading pump will work. Press the
button again , threading pump will stop.
MODE 2:
Press the " Push to thread needles button"
once, threading pump will work 3 seconds and
then stops.
MODE 3:
Press the " Push to thread needles button",
threading pump will operate while keeping
button pressed.
Note: Your Acclaim is set to MODE 1 at the
factory
ࠐ
㹶
A
B
C
D
L R
Push to
thread needles
button
Power switch