17
2. VEHICLE INSTALLATION POINTS
WHERE:
In the vehicle rear seats.
HOW:
GROUP 2/3 •Install forward facing.
In seats with:
ISOFIX anchorages (between seat and backrest) and 3-point belt (vehicle belt).
NOTICE:
The child seat must only be used in this seat IF it has a lap and diagonal belt
(3 points).
Please, do NOT install the safety seat in forward seats except for the following
cases:
1. Whenever the vehicle does not count with rear seats.
2. When all rear seats are already occupied by children exceeding 135 cm
height.
3. When it is not possible to install all child restraints systems in the rear seats.
2
1
*Note: According to Spanish legislation for child restraint systems (Royal Decree 667/2015).
3. CAR SEAT GENERAL USE
3.1. Seat reclining positions.
This restraint system has four reclining positions. Before installing the child on
the seat, select the reclining position by pulling of the lever situated between the
seat and the base (fig. 3.1).
3.2. Adjusting the headrest.
A correctly adjusted headrest
(A)
ensures that the diagonal part of the safety
belt is ideally positioned, offering the child the best possible protection.
The headrest should be adjusted so that a space equivalent to two fingers remains
between the headrest and the child’s shoulders (fig. 3.2).
To adjust the height of the headrest:
1. Pull the headrest height adjuster
(G)
and the headrest at the same time. This
will unlock the headrest (fig. 3.3).
2. Now you will be able to move the headrest to the desired height. When the adjuster
is released the headrest will remain locked in the chosen position (fig. 3.4).
3. Place the safety seat on the car seat.
4. Sit the child in the seat and check the height. Repeat the process until the
correct height is achieved.
