(8.2) Main line light parameter setting
The light module is automatically turned on and off based on the time status set for day and night.
The light intensity can be set in the interface, with a minimum light intensity of 10% and a maximum
light intensity of 115%.
(8.3) HID delay parameter setting
After setting the delay of the HID lamp in the interface, when the device is turned off, the delay time
required to wait for the response is enabled again, which is from 3min to 180min.
(8.4) Sun r/s parameter setting
In the interface, the Sun R/S mode can be enabled and disabled as appropriate, that is, a fixed off time
can be set. If the time set is longer than 1 minute, the light intensity is switched by 5% each time; if the
time set is less than or equal to 1 minute, the light intensity is switched by 10% each time. If the time
is set to 0, it means that the status of sun r/s is not displayed.
(8.5) Channel 2 Setting
0
50％
115％
Sun R/S simulation
5％
5％
5％
5％
ON
OFF
Time
Output Max
Sunrise
simulation time
Sunset
simulation time
Target Output
28
