Measure
126
10.1.1 Voltage Mesasurements
Voltage measurements include 17 kinds of voltage parameters.
Figure 10.2
Voltage Measurements
Peak-Peak:
The difference between maximum and minimum data values.
Maximum:
The highest value in the waveform display.
Minimum:
The lowest vlues in the waveform display.
Amplitude:
The difference between the top and base value of the waveform.
Top:
The most commom value of the upper part of the waveform, or if the mode is not well
defined, the top value is the same as the maximum value.
Base:
The most common value of the lowerpart of the waveform. If the mode is not well
defined, the base value is the same as the minimum value.
Mean:
The sum of the level of the waveform’s samples divided by the number of cycles.
Cycle Mean:
The sum of the level of the waveform’s first sample divided by the number of cycles.
Stdev:
The standard deviation of all the waveform’s cycles.
Cycle Stdev:
The standard deviation of all the values in the waveform’s first cycle.
RMS:
The root-mean-square of the waveofrm over one or more full cycle.
Cycle RMS:
The root-mean-square of the waveform’s first cycle.
Overshoot:
The distortion that follows a major edge transition expressed as a percentage of Amplitude.
The X cursors show which edge is being measured (edge closest to the trigger reference
point).
𝑅𝑖𝑠𝑖𝑛𝑔 𝑒𝑑𝑔𝑒 𝑜𝑣𝑒𝑟𝑠ℎ𝑜𝑜𝑡 =
𝑙𝑜𝑐𝑎𝑙 𝑀 𝑎𝑥𝑖𝑚𝑢𝑚 − 𝐷 𝑇 𝑜𝑝
𝐴𝑚𝑝𝑙𝑖𝑡𝑢𝑑𝑒
× 100
Содержание 2510B Series
Страница 1: ......
Страница 17: ...Introduction 17 1 5 Front Panel Figure 1 3 Front Panel ...