Warning
Hot Surface
TOOLS
NEEDED:
1/8” Allen Wrench
1. Remove faceplate using a 1/8” allen wrench. If
there is an optional accessory holder, carefully
squeeze tabs on sides and gently pull from slots
on OptiLock.
2a. Firmly insert proper MR16 lamp into socket to
make connection.
Do not exceed the maximum wattage listed on
the fixture label before installing.
Lamp Installation Or Re-Lamping
MR16 Lamp Installation
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION
INSTRUCTIONS
RELEASE DATE
10/13/2021
REFERENCE NUMBER
INS-2856-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR
SELL ANYTHING IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
HP2
Shallow Housing - Standard MR16 & PAR36/AR111
Lamp and Accessory Holder Installation
2b. Install proper PAR36/AR111 lamp by placing
connectors around loosened terminal screws,
then gently tightening screw to make connection.
Do not exceed the maximum wattage listed on
the fixture label before installing.
PAR36/AR111 Lamp Installation
3. Remove any dirt or debris in o-ring groove near
top of housing. Place o-ring inside of groove.
Failure to clean groove of debris will cause
fixture to fail and void product warranty.
4. Install faceplate using a 1/8” allen wrench and
hand-tighten the faceplate screws in a star pattern
to 30 in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
