Bischoff & Bischoff GmbH | 01.06.2019
EN
61
60
Taiga
| Electric Wheelchair
Electric Wheelchair |
Taiga
3.5.6. Seat suspension
•
You can adjust the seat suspension to your weight for comfortable
driving (fig. 15)
•
A special spanner is required in order to adjust the spring travel
(please contact service).
•
Compression of the spring is equivalent to a low spring travel and a
„harder“ setting.
•
Releasing the tension of the spring increases the spring travel and
ensures a „softer“ setting.
3.5.7. Armrests
The armrests can be completely taken off to be able to get in and out
of the chair from the side. In addition, the height of the armrests can
be adjusted. They can also be adjusted sideways by adjusting the side
parts (see side parts).
Removing the armrests
•
To remove the armrest, loosen the wing bolt and pull out the
armrest to the top (fig. 16).
•
When installing the armrest, make sure it is inserted all the way
and fastened again.
Adjusting the height
•
First remove the arm rest from the bracket.
•
Remove the check screw (fig. 17) and screw it into the desired
position of the arm rest.
•
The lowest hole corresponds to the max. height setting of the arm
rest.
3.5.8. Side parts
You can slide the side parts sideways.
•
Undo the fastening screw underneath the seat and slide the side
part into the desired position (fig. 18).
•
Tighten the screw again.
3.5.9. Control unit
The control unit can be mounted either on the right or left-hand side
underneath the armrest each. The control unit must be adjusted by a
qualified mobility dealer to warrant safe functionality of the wheelchair.
Distance from the armrest
•
You can adjust the position of the control unit to your forearm
length.
•
Loosen the hand screw on the outer side of the side part.
•
Move the control unit into the desired position, then tighten the
screw again (fig. 19).
Adjusting the height
•
The distance to the armrest can be adjusted.
•
Loosen the screw connection on the inner side of the side part.
(fig. 20)
•
Move the control unit into the desired position, then tighten the
screw again.
16
15
19
18
17
Ensure that the adjustment is restricted to the
marked range!
Ensure that both shock absorbers, right and left, are
adjusted the same.
Please note that the wires to the control unit must
be laid anew. Have this done by a technician.
20
