1.
INPUT:
Plug your guitar in here. Always use a high-quality,
shielded instrument cable.
2.
OVERDRIVE CHANNEL - GAIN:
Adjusts the amount of
Drive or Distortion.
3.
OVERDRIVE CHANNEL - BASS:
Adjusts the amount of low
frequency boost or cut as desired in the overdrive channel.
Bass is B-52's signature. Turning this control clockwise
increases depth and low-end punch.
4.
OVERDRIVE CHANNEL - MIDDLE:
Adjusts the amount of
mid-range frequencies as desired in the overdrive channel.
The Middle control adds body and punch to your sound.
5.
OVERDRIVE CHANNEL - TREBLE:
Adjusts the amount of
high frequency boost or cut as desired in the overdrive
channel. Turning this control clockwise adds clarity.
6.
OVERDRIVE CHANNEL - CONTOUR:
Varies the critical
midrange tone in the overdrive channels. Adjusts from “classic”
midrange punch to “scooped metal” madness.
7.
OVERDRIVE - VOLUME:
Controls the overall loudness of the
channel.
8.
CHANNEL SELECT:
Push switch selects between the clean
and overdrive channels. Activated LED lights indicate which
channel is in use.
9.
CLEAN CHANNEL - BASS:
Adjusts the amount of low
frequency boost or cut as desired. Adding bass will increase
the depth and fullness of your sound.
18. AC INLET & PRIMARY FUSE:
Connects AC powercord and
houses primary fuse.
Always use correct value as indicated on amp panel chart.
19. POWER TUBE FUSE:
This fuse protects the AT-112 against
circuit damage caused by a power tube failure. Only replace
with a 1 AMP Fast Blo (never Slo Blo) fuse.
20. LOUDSPEAKER OUTPUTS:
Connects the AT-112 to the
internal 12” speaker. The extension output can be connected to
an additional speaker enclosure.
Be sure the impedance switch is
properly set. The correct setting for the AT-112 is 8 ohms when
no extension speaker is connected.
NOTE:
Always be sure the
speakers are plugged in before attempting to operate the amplifier. Severe
damage can occur from failing to connect the speakers to a tube amplifier.
21. IMPEDANCE SELECTOR SWITCH:
Allows the AT- 112 to
safely operate into any 4 ohm, 8 ohm or 16 ohms.
NOTE:
Proper setting of the switch is critical for reliable operation.
To reduce the risk of fire or electrical shock, do not expose this unit to rain
or moisture. Do not operate your AT-112 near a pool or other standing
water. Make sure all blades on the polarized power plug are fully inserted
into the power source. Ensure the powercord is not stretched, pinched or
otherwise abused. Ensure the power cord is routed to avoid foot traffic.
Your AT-112 amplifier should be cleaned only with a dry cloth.
WARNING:
SHOCK HAZARD!
4
AT-112 CONTROLS AND FEATURES
