5
22. LINE OUT LEVEL CONTROL:
Controls the signal level of
the Line Out Jack.
23. LINE OUT JACK:
Connects the AT- 112 to an external
line-level device.
24. FOOTSWITCH - CHANNEL/REVERB:
Connects footswitch to
turn the reverb on/off and to switch between the Clean and
Overdrive channels.
25. EFFECTS - RETURN JACK:
Connects the AT-112 to the
output of an effects unit.
26. EFFECTS - RETURN LEVEL:
Controls the input level of
the returning signal from an effects unit.
27. EFFECTS - SEND LEVEL:
Controls the signal level output
to an effects unit.
28. EFFECTS - SEND JACK:
Connects to the AT-112 to the input
of an effects unit.
10. CLEAN CHANNEL - MIDDLE:
Adjusts the amount of mid-
range frequencies as desired in the clean channel. Turning the
middle control clockwise will increase the amount of warmth in
your tone. Counterclockwise settings create a more pristine,
acoustic kind of sound.
11. CLEAN CHANNEL - TREBLE:
Adjusts the amount of high
frequency boost or cut as desired in the clean channel. Turning
this control clockwise will add brilliance to your sound. Turning
the control counter-clockwise softens the tone.
12. CLEAN CHANNEL - VOLUME:
Controls the overall loudness
of the clean channel.
13. MASTER LOW RESONANCE:
Controls the overall resonance
of the amplifier. Turning the control clockwise adds rich low end.
14. MASTER REVERB CONTROL:
Adjusts the amount of reverb
produced by the amplifier. To increase the amount of reverb
turn clockwise.
15. PILOT JEWEL:
Power on indicator.
16. STANDBY ON/OFF SWITCH:
Allows the AT-112 to remain
turned ON for limited periods of inactivity. When the Standby
switch is in the STANDBY position the AT-112 is in a non-
operational setting. When in Standby the tubes remain
hot and ready for use. This bypasses the time required for the
tubes to warm up before use. When the Standby switch is in
the ON position the AT-112 is operational. DO NOT turn on the
AT-112 or have the switch set to ON without it connected
to a loudspeaker.
17. POWER ON/OFF SWITCH:
Turns the AT-112 on and off.
Do not attempt to service the
AT-112 by yourself. Refer all
servicing to a B-52 Authorized
d e a l e r. Service is required
when the AT-112 has had liquid
spilled on it or has been dam -
aged in any way, the amplifier
has been exposed to rain or
moisture, does not operate
normally or has been dropped.
PRECAUTIONS
AT-112 CONTROLS AND FEATURES
