AZZA 6IFB, Руководство по эксплуатации

Страница: 34 / 35

PT-6IFB
SYSTEM BOARD
AWARD BIOS SETUP
I.
3
6. Attach the small end of the power cable (F) to the three-pin connector on the
processor, then attach the large end to the three-pin connector on the
motherboard. Consult the motherboard documentation to find the connector.
E
F
D
A. Removing the Processor
First, remove the motherboard from the chassis. To remove the processor from the
motherboard, follow these steps (the reverse of the installation process).
1. Disconnect the fan power cable from the motherboard. (We recommend that you
leave the cable connected to the processor.)
2. Slide the clips on the supports backward to release the pegs in the motherboard.
Push the latches on the processor toward the center of the processor until they
click into place.
3. Lift one end of the processor until it is freed from Slot 1. Lift the other end of the
processor until it is freed from Slot 1. Lift the entire processor (with the fan
heatsink supports attached) until it is free from the retention mechanism.
4. Remove the heatsink support pegs from the motherboard and discard them. With
one hand, squeeze together the two halves of the peg on the bottom side of the
motherboard. With the other hand, pull the peg out of the hole in the motherboard.
Do not reuse the pegs.