Aztech IP 200, Руководство пользователя

Страница: 47 / 72

IP 200 User Manual
Page 47 of 72
Call Waiting tone is played at an interval of 10 sec. for USA. It is configurable using
the Call Waiting tone parameters.
Disconnect Timeout (Secs):
Enter the length of time in seconds the Fast-Busy tone
will be played once a call has been disconnected by the remote-end. At the end
of this period, the Warble tone will be played until the user hangs up the phone.
Call Forward No Ans Timeout (Secs): Enter the length of time in seconds after which
the call will be forwarded when it is not answered.
RingBack Timeout (Secs): Enter the length of time in seconds ATA will wait while the
RingBack tone is being played for the final response from the other end point once
an outgoing call has been made and the initial response has been received.
Note:
All Timeout parameters
do not require a Save & Reboot to take effect.
Submit: Applies all the settings you did in this page.
Note: After clicking
Submit
to save page settings to system RAM, you must
permanently save the configuration and reinitialize the system as follows.
Save Settings: Click this link to go to the Save Settings / Reboot page. On the Save
Settings / Reboot
page, click
Save & Reboot
to permanently save the settings to
system flash memory and to reinitialize the system to the new settings.
Ringtone Configuration
This page defines parameters for the various tones (ring, dial, busy,
ringback, etc.) generated by the ATA application. These parameters
may vary from country to country. Strongly recommend user to keep
these parameters by default.
Figure 25 Ring & Tone Configuration page