Aztec Tents QWIK-TOP FRAME, Руководство по эксплуатации продукта

Страница: 11 / 32

www.aztectent.com
Step 9:
Connect and pin an additional set of rafter pipes to the top tee fi tting
at the end of your fi rst ridge pipe. For 40’ wide tents you will also need
to slide the 40x Slide intermediate fi tting half way up each rafter and
secure from sliding by tightening the thumb screw on the underside of
the fi tting. Additionally, install the assembly cable by placing the large
loop of the assembly cable over a perimeter arm of the tee fi tting and
stretch the cable across the tent to loop over the perimeter arm of the
opposing tee or special side tee fi tting. This process will continue for
each additional beam arch that you construct.
Step 10:
For 40’ wide tents you will now connect and pin the 14’4” rafter
diagonal brace pipe to fi rst the 40x Slide Intermediate fi tting then to the
special tee on the eave of the tent. Once that is completed on both side
of the tent, and for all smaller tents you will install the eave pipes to the
eave fi ttings and pin into place.
Step 11:
Continue building extensions to the frame by adding additional ridge
pipe, top tee fi ttings, diagonal braces (as needed by size), and perimeter
pipes. Connect and pin each of these connections as you work down
the frame.
Step 12:
Add an additional set of rafter pipes to complete the next beam arch
and install the assembly cable to span from eave fi tting to eave fi tting.