Aztec Tents QWIK-TOP FRAME, Руководство по эксплуатации продукта

Страница: 15 / 32

www.aztectent.com
Step 25:
Position a tent jack next to each leg along the length of the tent and
slowly and evenly raise one side of the tent frame off the ground. Once
the frame is at an adequate height, connect and pin the leg poles to
the perimeter fi ttings and connect and pin the Qwik baseplates to the
bottom of the legs. Once the legs are all installed you can lower the
frame so the legs hold the weight of the tent on the ground. Disconnect
the tent jack straps from the frame and reposition the jacks on the
opposite side of the tent.
Step 26:
Position a tent jack next to each leg along the opposite length of the tent
and slowly and evenly raise this side of the tent frame off the ground.
Once the frame is at an adequate height, connect and pin the leg poles
to the perimeter fi ttings and connect and pin the Qwik baseplates to the
bottom of the legs. Additionally connect and pin all the remaining legs
and baseplates along the end of the tent at this time. Once the legs are
all installed you can lower the frame so the legs hold the weight of the
tent on the ground.
Step 26:
Using the included tieback ropes, loop a rope around each eave
fi tting and tie to the fi tting using an overhand slip knot. Drive your
anchor stakes vertically into the ground so that all but a few inches is
embedded into the ground. Position these stakes at a distance equal to
the leg height of the tent at an angle perpendicular with the eave frame.
Tie the tieback rope in between the head of the stake and the ground
and tighten until secure. If you are unable to tension to rope fully, you
can drive the stake further into the ground until the rope is taught.
Step 28:
Tension the tent top. At each leg you will need to apply tension down to
the base plate to ensure the proper fi t and performance.
Each tent top section ends with a 2” D-Ring and a 1/4” braided rope
extends out from the valance hem. The round ring on the end of this
rope MUST be passed through the D-Ring on the adjoining fabric
section and then down toward the base plate. Use the included 1”
tensioning ratchets to “hook” both of the round rings of the adjoining
sections and tension toward the base plate.