AzenX AZ-SBC98, Руководство по установке

Страница: 6 / 9

5
system could be also processed continuously and normally.
„ When the new hard disk is replaced, SATA SUB RAID V3 will enter “auto-rebuild”
mode automatically, and meanwhile the LCD will indicate “Rebuilding” to imply that
the backup is processing. When auto-rebuild is completed, the LCD will return to the
normal status.
„ Under the normal operation, when the fan is in damage, symbol F will appear at the
upper right side of LCD indicator, and buzzer alerts at the same time.
Remarks
„ When the LCD or LED is not workable, please reboot the system, to make sure if
indicator is in damage.
„ LED is the signal indicating how the hard disk reads.
„ Please make sure that HDD 1 and HDD2 are with the same capacity.
„
When the temperature is increasing, the fan will adjust the rpm (revolution per minute)
accordingly to cool down. On the other hand, the fan will decrease rpm to assure the
lifetime.
„ The fan adjusts rpm automatically in three levels
：
1. When it’s less than 30
℃
, the fan stops operating.
2. When it’s 30
℃〜
45
℃
, the fan operates 50% as 1300 rpm.
3. When it’s higher than 45
℃
, the fan operates 100% as 2600rpm.
„ When adopting High-speed backup at the first time, the system will auto-rebuild
completely. After re-build is completed and remove the backup device, the system
will record what content changes in the future. When the backup device is put into
SATA SUB RAID V3 again, the system will also enter High-speed re-build mode
automatically, and SATA SUB RAID V3 supports two backup devices for High-speed
mode. (Please note that the backup device under High-speed mode can’t be used other
computer systems except SATA SUB RAID V3 system. Otherwise, when adopting
backup function, it may cause data loss and fail in High-speed backup.)
„
Under High-speed mode, SATA SUB RAID V3 supports one source device backup
against two backup devices for record. From the third and further backup device,
when they are put into SUB RAID V3, the backup will be processed in Normal mode
without backup records. (Note
：
Users must remember which backup device is with
High-speed record, and only combined with original source device would the
High-speed backup processed. )
„ When adopting High-speed mode, and there are two High-speed backup devices
recorded, if other backup devices would be changed as High-speed backup, it must to
re-configure against the original source devices and two existing High-speed backup
devices with record.