AB-6675
15
To keep IP54 protection (dust-proof and splash-proof),
Use a water-proof connector for the ACTIVAL in a high-humidity environment or outdoor location. Through wiring port with the
seal connector (Part No. 83104346-00X) attached to, 1 cable can be lead in. Through wiring port with the SAnet cable gland
(with three ports) and the seal connectors attached to, 3 cables can be lead in.
Be sure to completely close the terminal cover and the top cover.
Waterproof the knockout hole.
- In accordance with the diameter of the cable used, select a suitable waterproof connector from
“Model Numbers,”
“Options”
- To daisy-chain the SAnet line, use the SAnet cable gland with three ports and the seal connector Azbil Corporation
supplies.
- For conduit connection, use a water-proof plica tube or the like.
Address Setting (Addressing)
WARNING
Before setup or engineering work, be sure to turn off power that is supplied from external devices to the output
terminals. Failure to do so may cause electric shock.
CAUTION
Do not put a load or weight on this product.
Doing so may damage the product.
Before setup or engineering work, be sure to turn off power that is supplied from external devices to the output
terminals. Failure to do so may cause electric shock..
Do not carelessly touch this product when it is used to control hot water.
Doing so may result in burns, because the product reaches a high temperature.
To SAnet interface module, ACTIVAL Model VY5460F and other Intelligent Component Series devices including ACTIVAL
PLUS and damper actuators are connected via SAnet. Set address for the terminal devices (Intelligent Component Series
devices) so that the SAnet interface module can recognize all the terminal devices connected. Follow the procedure below to
set the address. For details regarding address setting (addressing), ask our sales/service personnel.
1) Unscrew the setscrews and remove the terminal cover. See Fig. 16 for removing the terminal cover.
2) Set address. (See Table 1.) Address can be set with rotary switch, with service pin switch, or based on SAnet ID. Rotary
switch and service pin switch are provided on this product. To set the address with rotary switch or based on SAnet ID, Data
Setter or PC-MMI is required. Set the address in either way according to your availability.
Setting with rotary switch:
Turn the rotary switch using a precision Phillips screwdriver and set.
Setting with service pin switch:
1. Set the rotary switch to ‘0’.
2. Start addressing operation* of Data Setter or PC-MMI.
Then, press the service pin switch. Do not keep the
switch pressed for longer than 5 seconds.
3. Address is set within 5 seconds after pressing the
service pin switch.
For the addressing operation of Data Setter or PC-MMI, ask
our sales/service personnel.
Setting based on SAnet ID:
1. Set the rotary switch to ‘0’.
2. With Data Setter or PC-MMI, enter the SAnet ID (on the
product code label) and address number to set. The
product code label is attached on the side surface of the
actuator, as shown in Fig. 20.
For the addressing operation of Data Setter or PC-MMI, ask
our sales/service personnel.
3) Attach the terminal cover after setting the address.
LED
Service pin switch
(for Data Setter/PC-MMI)
Rotary switch
Terminal block
Figure 19. Terminal block, LED, setting switches
(without terminal cover)
Figure 20. SAnet ID on the product code label
SAnet ID
