AZALEA AVIATION SPYDER 100 HP, Инструкция по сборке

Страница: 38 / 65

Section 8 - 6
Azalea Aviation Copyright 2014
With the tubes in place screw the rocker plate/bolt assemblies into place. Tighten
them finger tight. Double check all work before proceeding to torquing the head.
Use the 9/16” and 13/16” sockets to snug up the head.
Once finished, turn the
crankshaft over a couple times to insure smooth rotation and no binding. If binding
is encountered remove the head and check for obstruction. Use the torque
sequence and pattern to bring the head up to final torque. (Fig 9) Use the torque
wrench in a steady and smooth motion. Once it “clicks” , hold that position for a
few seconds to let the stud and nut settle.
Fig 9. Head Torque Sequence
Once both head have been torque to the proper amount and in the correct sequence,
use a clean cloth or paper towel and clean any excess grease or oil off of the
pushrod tubes/case/head area. This will reduce the amount of “smoking” the
engine will do at startup. Also, a clean engine is a “goodly” engine.