AZALEA AVIATION SPYDER 100 HP, Инструкция по сборке

Страница: 14 / 65

Section 5 - 2
Azalea Aviation Copyright 2014
Installing Oil Cover Plate
Spray copper spray onto both sides of the oil cover gasket. Once it is tacky, place
onto the case and bolt the cover plate into position. Torque the bolts to 150 “ lbs
or 13 foot lbs. Spray copper spray onto the block off plate gasket and bolt the
block off into place with same torque. (Figure 1, Figure 2)
Fig 1. Oil Cover in Place
Install the ring gear and loosely snug up the six bolts. Install the starter and check
for fit. Check the clearance on the ring gear to bendix gear on the starter. Have
at least a 1/8” space. Adjustments can be made by placing a washer under the
top starter bolt. The top of the gear should be in line with the “flat” spot on the
starter nose. (Figure 3) Tighten the main starter bolt with it in this position. If
you are installing a new starter kit the Lower Bracket may need to be drilled and
fitted to hold the starter in place. Remove the ring gear and bolt the Starter and
lower bracket into position using Loctite on the bolts/nuts. (Figure 4) Reattach
the Ring gear using red Loctite on the bolts and torquing to 30 ’lbs.