AZALEA AVIATION SPYDER 100 HP, Инструкция по сборке

Страница: 32 / 65

Section 7 - 8
Azalea Aviation Copyright 2014
Installation of Pistons and Cylinders:
Install the rings onto the pistons as per included directions. Mark each piston to
be sure the offset is properly positioned when assembling into the cylinders. Wet
the inside of the cylinder with a light coating of oil and gently install the pistons
into the cylinders from the bottom. Use a blunt screwdriver or wooden stick (like
tongue depressor) to push the rings into the grooves while installing. Push the
cylinder into the piston up to the wrist pin opening. Because these are free
floating wrist pins, the snap ring will have to be installed on one side of the piston
before installing onto the rods. Spray the copper base gaskets with a light coating
of sealant and install onto the cylinders. Position the cylinder and piston
assembly onto the rod and slide the lubricated wrist pin into position until it
bottoms against the snap ring. Install the other snap ring to lock the wrist pin in
place. Push the cylinder into the case. Once you have three cylinders installed
on one side, install the baffle and loosely install a head to hold into position.