Ayrton Mistral S, Руководство пользователя, Страница: 15 / 36

14
8. DEVICE DMX START ADDRESS SELECTION
All fixtures should be given a DMX starting address when using a DMX signal so that the
correct fixture responds to the correct control signals
.
This digital starting address is the channel
number from which the fixture starts to
“
listen
”
to the digital control information sent out from the
DMX controller
.
The allocation of this starting address is achieved by setting the correct address
number on the display located on the base of the device
.
You can set the same starting address for all fixtures or a group of fixtures or set different
addresses for each fixture individually
.
If you set the same address on all devices all the devices will start to
“
listen
”
to the same control
signal from the same channel number
.
In other words changing the settings of one channel will
affect all the fixtures simultaneously
.
If you set a different address each unit will start to
“
listen
”
to the channel number you have set
based on the quantity of control channels of the unit
.
That means changing the settings of one
channel will affect only the selected device
.
In the case of the LED moving head in39channel mode you should set the starting address of the
first unit to 1
the second unit to 40(39 + 1) the third unit to 79 (39 + 40) and so on
.
9. DISPLAY
The Display offers Rotary knob features you can set the starting address run the
pre-programmed program or reset the device
.
The main menu is accessed by double clicking the rotary knob of rotary knob until the display
starts flashing
.
Browse through the menu by turning rotary knob clockwise or counterclockwise
.
Press theRotary knob for 2 seconds in order to select the desired menuor exit menu, double click
the
Rotary knob
for confirm
.
After accessing the edit mode the unit will automatically exit to the
main menu after 15 seconds from the last button press
.
Clockwise is positive direction while
counterclockwise is opposite direction
.
When the unit is powered on if no data signal is connectedafter 1 minute then the display will
switch off automatically
.
The Displaydoes not need external power to operate in case there is
battery hold down therotary knob for seconds and the Display will turn on by usingthe unit’s
battery
.
PS No response when quick press the rotary knob
.