Ayrton DREAMPANEL TWIN, Руководство пользователя

Страница: 8 / 19

USER MANUAL _
8
INSTALLATION METHOD USING TRUSS HOOKS
Refer to the following diagram when installing the DREAMPANEL TWIN
with truss hooks using omega bracket:
• Attach the clamp to the omega bracket using an M12 screw.
• Insert the quick-lock fasteners of the first omega bracket into the
respective holes on the base of the unit. Turn the quick fasteners fully
clockwise.
• Install the second omega bracket.
• Insert the safety cable through the holes at the bottom of the base and
the truss or a stable attachment point. Insert the end into the hole and
tighten the safety screw.
Note: The last step is very important to ensure that the luminaire does
not fall.
ARTNET CONNECTION
Connect the Ethernet input (RJ45 connector) cable of the luminaire to
the Ethernet output (RJ45 connector) of your controller. You can connect
multiple luminaires to this same line in a daisy chain.
Refer to the following diagram when connecting the DREAMPANEL TWIN
luminaires in a daisy chain:
Address 41 Address 21 Address 1
THE DREAMPANEL TWIN DMX ADDRESS SETTING
All luminaires have a DMX start address correctly set when using a DMX
signal to control them. The DMX start address is the channel from which
the luminaire “listens” to the digital control information sent by the DMX
controller.
The start address must conform to the one recorded on the DMX controller
to run the luminaire. This address is the DMX value that appears on the
luminaire’s display. You can set the same address for all the luminaires, or
some of them, but you can also set a different address for each luminaire,
as needed.
If you do set the same address for all the luminaires, they will all “listen”
from the DMX channel you have set. The instructions sent by the DMX
controller will affect all luminaires at the same time. If you set a different
address per luminaire, the DMX controller can control each independently.
If, for instance, the fixtures are preset in 20 channels DMX mode, you will
need to adjust the DMX address for the luminaires as follows: The first unit
with DMX address 001, the second with DMX address 021 (20 + 1), the
third with DMX address 41 (20 + 21), etc.
CONTROL PANEL (MENU OPTIONS)
A large number of settings are accessible from the fixture’s control panel.
A good working knowledge of it will enhance the fixture’s possibilities.
You can access the Main Menu by pressing the key until the display
flashes.
Cycling through the menus is performed by pressing the , ,
or keys, as required:
• Press the key to select the desired menu.
• Change the selection by pressing the , or , keys.
• Confirm your selection by pressing the key.
• Exit a menu at any time by pressing the key.
Notes:
You can return the display by pressing the or keys from the
basic display. If the screen fails to respond, hold the “Mode Esc” key down
for at least 3 seconds to free up the display.