6
Select AyrMesh
Enter Ayrmesh1
Using the AyrMesh
Hub
To access the Hub's WiFi Access Point:
- Click on the Wireless icon on your
computer, or select the WiFi settings on
your tablet or smartphone
- Select the AyrMesh network from the list
of available WiFi Access Points (default
"AyrMesh" unless changed in AyrMesh.com)
- Enter the Encryption Passkey when
prompted - default is "Ayrmesh1" (note
the capital "A")
NOTE: Once you have tested the Hub,
MAKE SURE you CHANGE THE
ENCRYPTION PASSKEY (and SSID if
desired) on AyrMesh.com to ensure the
security of your network.
Note that changes on AyrMesh.com may take
half an hour or more to take e
�
ect. The Hubs
wait to make sure all the devices on your
network receive the new con
�
guration.
Wireless network selection in Windows
Remote Hubs
use the signal lights to show the signal strength to the nearest Hub.
The signal strength is exhibited as follows:
- Just the
�
rst (red) signal light - very low signal
- First and second (yellow) light - good signal
- First, second, third (green) light - excellent
- All 4 signal lights - Hubs may be too close
The signal lights on a Remote Hub are refreshed approximately once per second.
5
Signal Lights on the Hub
Top Signal light - green
Third Signal light - green
Second Signal light - orange
First Signal light - red
Ethernet activity light - blue
Power light - blue
Gateway Hubs
have the following
lights on:
Top Signal light
Ethernet activity light
Power light
