ULTRA-QUICKSTART GUIDE
These directions are minimized for more knowledgeable/experienced installers.
For the "regular"
�
uickstart instructions, turn these directions over. For more
detailed instructions, please see https://support/ayrstone.com
GET READY: Write down the MAC address of the Hub and put it someplace safe.
If you haven't already, create an account on AyrMesh.com from a computer connected to
the same router that the Hub will be connected to. This ensures you won't have to enter
the Hub's MAC address manually. If you create the account from a di
�
erent IP address
(e.g. from your phone connected to the cellular network) then enter the IP address in
your AyrMesh.com account.
2
ASSEMBLE: Screw the antenna into the mounting bracket (
�
nger-tight, no tools), then
screw the Hub onto the bottom of the antenna (again,
�
nger-tight). Unscrew the cap on
the bottom of the Hub, exposing the Ethernet port.
1
00:C0:
MAC Addr:
®
3
INITIALIZE: With an Ethernet cable, connect the LAN port of the
Power Supply to your router. With another Ethernet cable, connect
the PoE port of the Power Supply to the Hub. Plug in the power
supply (lights on the Hub will go on). Wait until the Hub checks
in to AyrMesh.com - the signal lights will "run" from bottom to
top, then the top signal light will remain lit. This should take
about a minute.
®
4
INSTALL: Mount the Hub outdoors, as high and "in the clear" as possible. Run a long
(preferably shielded - STP) Ethernet cable from the power supply (which must be kept dry) to
the Hub - remember to leave a "drip loop" where the cable enters the building to prevent
water from coming down the cable inside. The Gateway Hub must have the "LAN" port of
the power supply connected to the Router; Remote Hubs have the LAN port available for
connecting other devices.
Thread the end cap onto the Ethernet cable,
then slide the "gland" onto the cable and press
it into the end to make it weather-tight.
