Playback
Playing a scene
1. Tap the Mode Select button to select the Chase<>Scene mode
2. Tap the Page button to go to the page where your Scene is stored
3. Push Master Fader B to its maximum position (
NOTE: 100% intensity = full down!)
4. Move the desired Channel fader (13-24) to its maximum position, the Scene will fade in smoothly,
depending on the selected fade time.
5. Move the Channel fader to adjust the intensity of the current program
NOTE:
The current mode is indicated by 3 LEDs. Red is the Chase <> Scene LED. Yellow is the A/B
selection, green is the 1-24 single mode LED.
Playing a scene to audio triggering
1. Select your Scene as described above
2. Tap the Audio button until the LED lights up, indicating that the AUDIO mode is active.
3. Use the Audio Level fader to adjust the sensitivity. Pay close attention to the behavior of your connected
light and the change in values on the controller.
4. To return to the normal mode, tap the Audio button a second time, causing the LED to turn off and to close
the mode.
NOTE: You are free to choose one of the audio-activated options. Use the built-in microphone, or use
a line-signal from a music signal source, such as a PA- or DJ-mixer.
Playing a scene with the speed slider
1. Select your scene as described above
2. Move the Speed slider to SHOW MODE position (full down)
3. Press and hold the REC Speed button and tap the corresponding Flash button (13-24). The scene tapped
will no longer run on the standard programmed speed. Move the Speed Fader to correct the playback speed.
Playing a scene with the standard beat
1. Tap the MODE Select button to select Chase<>Scene mode
2. Tap the Park button to select Mix Chase mode. The LED will activate, indicating that the mode is selected.
3. Select your Scene as described above.
4. Move the Speed fader until the display reads the selected value
5. Press and hold the REC Speed button and tap the Flash button (13-24) you wish to apply the speed
setting on
6. The Scene will now run with the new selected time/beat when activated
7. Repeat steps 4 and 5 to set a new beat time.
NOTE:
Check if the Audio mode is disengaged. As an alternative to the Speed slider, you may also use the
Tap Sync function to determine the time between steps
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0
Creation date + author initials: 29-03-2014 RV Revision date + author initials: 29-03-2014 RV